Connector Board Set CB30C (Molex LFH160)

For 160-pin Molex LFH™ (low-force helix) connectors. Because of the complex and dense nature of these connectors, we do not advise customer-installation unless proper wave soldering equipment is available. Note that these mating connectors are expensive and may require some lead time to obtain.

Molex Connector Part Number (two required): 71624-1003
Mating connector is Male for Female Cable Connector

Important: These CB30C boards are daughter boards intended to mount on a set of CB30s (see Photo 2 below). Plan on ordering a set of CB30s with the CB30CB if you do not already have a set.

Set of two boards with four 64-pin latch headers. Requires 384 test points and a set of CB30 boards. Note that the latch headers supplied with the CB30C should be mounted to the CB30 boards to accommodate the 64-pin sockets on the bottom of the CB30C; CAMI Research will configure this for you if the CB30s are ordered at the same time as the CB30C.

Rated for operation up to 500 Vdc/ac.